Customer Guide: How to Install our MDF Wall Panels 

A simple solution to modern styling, our MDF ribbed and MDF fluted flow wall panels are an easy-to-install option for any homeowner looking for a unique feature. 

All of the NE Panel's MDF range is pre-primed, meaning its ready to paint with minimal prep - so you can spend more time choosing paint samples without worrying about excessive sanding and additional supplies to get started. 

Why Choose NE Panels' MDF Wall Panels? 

• There's something for everyone: Our MDF panels come in two styles, ribbed and fluted, with a range of sizing and finishes. 
• Ready to paint: There's no worrying about priming and getting the panels ready with NE Panels. We've worked directly with our manufacturers to give our customers the best quality MDF pre-primed panels on the market. 
• Suitable for any room: Our panels are made from a moisture-resistant MDF, meaning you can install it in your bathroom or kitchen without worry. 
• Your local supplier: With our leading showroom in Teesside, our customers have the option of viewing our panels in person, and speaking to us to make the right choice for their home. 
• No long delivery times: We understand how frustrating it is to order panels online and be told that it's a 6-8 week delivery time. Our panels are available for delivery in as little as 1-3 days, with same day pick up available at our Teesside unit. 

What Do I Need to Install MDF Panels? 

To install our MDF Wall Panels, you will need: 

• NE Panels Wall Panels 
  
• Tape Measure
• Spirit Level
• Grab Adhesive 
• Sealant Gun 

You might also need: 

• Pencil
• Square tool
• Fine-toothed hand saw, Jigsaw or Multi-tool
• 120-400 grit sandpaper 
• Four to eight (1mm x 25mm) pins per panel (pin type dependent on the sub-wall composition) 
• Caulk 

Before You Start...

Before you go ahead and start installing your panels, make sure your wall is clean, smooth and level. If your wall is uneven, fill in any holes or sand down high spots to create a smooth surface. 

We recommend noting the placement of cables and concealed pipework to avoid them during installation. 

Make sure you remove any screws, nails or other fixtures from your wall.

Unbox all of your apckages and check the panels before installation. 

I'm Not Installing My Panels Yet... How Do I Store MDF Panels? 

MDF Panels should be laid flat if you need to store them to install at a later date. They need to be laid flat to minimise any bowing which could affect look and performance. 

How To Install MDF Wall Panels.

So you've done any prep work, but how do you actually install MDF panels? 

1. We recommend doing a test-fit with your panels first, holding them up to the wall to inspect your panels and check the measurements and cuts are accurate.
2. Sand each MDF panel down with 120-400 grit sandpaper, 400 grit for a finer finish. (5-10 mins per panel)
3. Apply Grab Adhesive in three wavy lines along the back of your first panel, covering its full length
   Top tip: We usually recommend that one tube of adhesive covers one panel.
4. Position the ‘first’ panel against your wall. Please note that this needs to be straight, so please use your spirit level for this. 
5. Apply pressure all along the panel and press firmly to secure it.
6. Repeat for each panel. 

After installing all your panels, caulk the join line where panels meet and any pin holes. Smooth it out with a filling knife and remove any excess with a damp cloth. Apply primer over the caulk before painting.

Once your finished installation is dry, it can be painted.

We recommend sanding lightly before, and in between, paint or primer coats for the best result.